Installation Sheet

1.0

Installation Instructions for

Voto Wall (LED)

700WSVOTC_-LED

920WSVOTOD

GP I :ENERAL RODUCT NFORMATION

Mount to either a 4" square electrical box with

round plaster ring or an octagonal electrical box.

Suitable for damp locations.

WCALL OLLECTION

Install the Fixture

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the fixture.

Remove the mounting plate from the back of the

fixture.

ALLEN WRENCH

SET SCREW

MOUNTING

PLATE

Attach the mounting plate to the electrical box using

the two provided #8-32 screws .

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
920WSVOTOD Installation Instructions for Voto Wall (LED) 700WSVOTC_-LED W ALL C OLLECTION GENERAL PRODUCT INFORMATION: Mount to either a 4" square electrical box with round plaster ring or an octagonal electrical box. Suitable for damp locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
1C DRIVER 5 3 4 6 4 Connect the backplate wire to a suitable ground in accordance with local electrical codes. 5 Connect the white driver wire to the neutral power line. 6 Connect the black driver wire to the hot power line. 1D SAVE THESE INSTRUCTIONS! 9 SET SCREW ALLEN WRENCH 7 Properly place all wires and wire nut connections into the electrical box.