Installation Sheet

Installation Instructions for

Vetra Wall

920WSVETRA

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

Incandescent version may be dimmed with a standard incandescent

dimmer. LED version may be dimmed with a LED dimmer. Consult

lamp manufacturer for additional information.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Mounting Plate

Connect the fixture to a suitable ground in accordance

with local electrical codes.

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

Loosen the set screw on bottom of(Do Not Remove)

the fixture arm with the provided Allen wrench.

Remove the mounting plate.

MOUNTING

PLATE

#8-32 SCREW

MOUNTING

PLATE

ALLEN WRENCH

SET SCREW

FIXTURE

ARM

1.0

700WSVTR

WALL

PAGE 1
Installation Instructions for 920WSVETRA Vetra Wall 700WSVTR 1.0 WALL GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
PAGE 2
Install the Fixture Install the Shade and Lamp 2A 3A POWER LINE WIRE FIXTURE WIRE POST SHADE 1 FIXTURE WIRE LAMP POWER LINE WIRE 1 2 Feed the fixture wires through the mounting plate post into the electrical box. SOCKET THREAD To connect the power, pull the fixture wires and power line wires out of the electrical box. FIXTURE ARM 2B 3 Refer to fixture marking for lamp information. Connect the white fixture wire to the neutral power line wire with a wire nut.