Installation Sheet

1
. Take Inventory
– Unpack the box containing (1) transformer, (2) turnbuckles,
(2) pieces of cable, (2) mounting posts, (5) fixtures,
(
5) 20 watt MR16 bulbs, (5) snap rings, and (1) packet
of mounting hardware.
(1) TRANSFORMER
(2) PIECES OF CABLE
(2) TURNBUCKLES
(2) MOUNTING POSTS
(5) MR16 BULBS
(1) MOUNTING HARDWARE
(5) SNAP RINGS
(5) FIXTURES
(1) TRANSFORMER MOUNTING HARDWARE
A
ccent
C
able
K
it
2
. Install The Transformer
– Turn the power to the electrical box off.
– Locate the transformer and the transformer mounting
hardware packet, which contains (2) screws and
(3) wire nuts.
– Remove and set aside the three screws from the
transformer to release the back plate.
– In accordance with local electrical codes, connect the
transformer ground wire. (typical installation shown).
– If green ground wire is present in electrical box, connect
it to green transformer ground wire with supplied wire nut.
– If green ground wire is not present in electrical box, cap
the green transformer ground wire with supplied wire nut.
ELECTRICAL BOX
TRANSFORMER
GROUND WIRE
(GREEN)
ELECTRICAL BOX
GROUND WIRE
(GREEN)
TRANSFORMER
M
OUNTING
HARDWARE
TRANSFORMER
BACK PLATE
2