Installation Sheet

4
(2) PIECES OF CABLE
(
2) TURNBUCKLES
(2) MOUNTING POSTS
(1) MOUNTING HARDWARE
3. Mount the Cable
–
Locate the (2) pieces of cable, (2) mounting posts,
(2) turnbuckles and the cable mounting hardware packet,
which includes (4) screws, (2) Allen wrenches,
(
4) drywall anchors, (4) threaded stems and (4) washers.
– Determine the general location for mounting the
turnbuckles and wall anchors. Keep in mind that the
transformer must be within 12 inches of the cables after
they are mounted.
– Using a pencil and tape measure, mark the location
of the mounting posts and the turnbuckles on the wall
(or ceiling) 3-1/2 inches apart.
3
-
1
/2
"
MAX 12 INCHES
– Line up the anchor with the mark on the wall and use a
hammer to tap anchor approximately 1/2 inch into the
wall. Stop just before the threaded portion of the anchor
enters the wall.
– Drive the anchor flush into the wall using a screwdriver.
DRYWALL
ANCHOR
WALL
NOTE
Do not install drywall anchors at any points in wall or ceiling
that may contain metal.
– Secure the washer to the flushed anchor by driving a screw
through the threaded stem, then the washer and into the
anchor. Repeat these steps for remaining mounting posts
and turnbuckle locations.
THREADED STEM
WASHER
– Use the larger Allen wrench to loosen the two set screws
(do not remove completely) on the mounting post.
MOUNTING POSTS
ALLEN WRENCH
A
ccent
C
able
K
it
Installation Options/Ideas:
Wall to Wall
Wall to Ceiling
Ceiling to Ceiling
MAX 12 INCHES