User Manual

4
(2) PIECES OF CABLE
(
2) TURNBUCKLES
(2) MOUNTING POSTS
(1) MOUNTING HARDWARE
3. Mount the Cable
– Locate the (2) pieces of cable, (2) mounting posts,
(2) turnbuckles and the cable mounting hardware packet,
which includes (4) screws, (2) Allen wrenches,
(4) drywall anchors, (4) threaded stems and (4) washers.
– Determine the general location for mounting the
turnbuckles and wall anchors. Keep in mind that the
transformer must be within 12 inches of the cables after
they are mounted.
– Using a pencil and tape measure, mark the location
of the mounting posts and the turnbuckles on the wall
(or ceiling) 3-1/2 inches apart.
3
-
1
/2
"
MAX 12 INCHES
– Line up the anchor with the mark on the wall and use a
hammer to tap anchor approximately 1/2 inch into the
wall. Stop just before the threaded portion of the anchor
enters the wall.
– Drive the anchor flush into the wall using a screwdriver.
DRYWALL
ANCHOR
WALL
NOTE
Do not install drywall anchors at any points in wall or ceiling
that may contain metal.
– Secure the washer to the flushed anchor by driving a screw
through the threaded stem, then the washer and into the
anchor. Repeat these steps for remaining mounting posts
and turnbuckle locations.
THREADED STEM
WASHER
– Use the larger Allen wrench to loosen the two set screws
(do not remove completely) on the mounting post.
MOUNTING POSTS
ALLEN WRENCH
A
ccent
C
able
K
it
Installation Options/Ideas:
Wall to Wall
Wall to Ceiling
Ceiling to Ceiling
MAX 12 INCHES