User Manual

– Screw the turnbuckle onto the threaded stem.
– Use the larger Allen wrench to loosen the two set screws
on the turnbuckle (do not remove completely).
– Stretch the cable from the corresponding mounting post
to the turnbuckle and feed it into the hole located on
the turnbuckle.
– Pull the cable through the side hole of the turnbuckles
until taut. While holding the cable taut, use the larger
Allen wrench to tighten the two set screws.
– Slide the smaller Allen wrench into the hole on the ball
screw for leverage. Tighten the cable by turning the ball
screw, while holding the turnbuckle barrel in place.
HOLD BARREL
BALL SCREW
EXCESS
CABLE
– Cut and remove the excess cable as close as possible to
the barrel of the turnbuckle. Repeat these steps for the
second turnbuckle and length of the cable.
5
– Insert the cable into the mounting post. Stop before cable
enters threaded portion of mounting post.
– Use the larger Allen wrench to tighten the two set screws
and secure the cable. The connection must be tight.
C
ABLE
STOP
THREADED PORTION
O
F MOUNTING POST
– Screw the mounting post onto the threaded stem and
repeat with the other mounting post.
– Unscrew the turnbuckle to its full extension.
TURNBUCKLE