Manualshelf

User Manual

ManualsBrandsTech Lighting ManualsCeiling LightsTiella 800CBL5PN, Accent Electronic Low Volt Surface Track Lighting Kits, 100 Watts Halogen, Nickel
12345678910
6
(5) MR16 BULBS
(5) SNAP RINGS
(5) FIXTURES
4. Install the Fixtures
– Locate the (5) fixtures, the (5) snap rings, and the
(5) MR16 bulbs.
S
LOTTED
THUMBSCREW
– Insert the pins of the bulb into the holes of the fixtures
socket. Tighten Allen screws on lamp socket with provided
Allen wrench. This connection should be firm, but not
overtightened.
THUMBSCREW
FIXTURE
CONNECTOR
USE A MAXIMUM 12 VOLT, 20 WATT,
MR16 FRONT COVER HALOGEN BULB.
A
ccent
C
able
K
it
– Connect the fixture between the cables. Push the fixture
connectors onto the cables.
– Screw the thumbscrews into the fixture connectors. Make
sure the thumbscrew connection is tight to avoid heat
build up and corrosion, which may cause an electrical
open circuit. Repeat for remaining fixtures.
– Place the MR16 lamp into the Snap Ring.
– Press the tabs on both sides of the Snap Ring against the
MR16 lamp to keep it in the position.
MR16 LAMP SNAP RING
TAB
– Remove the two thumbscrews from the fixture connectors.
LAMP SOCKETALLEN WRENCH