Manualshelf

User Manual

ManualsBrandsTech Lighting ManualsCeiling LightsTiella 800CBL5PN, Accent Electronic Low Volt Surface Track Lighting Kits, 100 Watts Halogen, Nickel
12345678910
POWER
CONNECTIONS
BULB
CONNECTIONS
FIXTURE
CONNECTERS
6. Check for Loose Connections
– Turn on the power to electrical box.
– Turn on the system and let it run for 5 minutes.
– Turn the system off and carefully check that all connection
points (power connections or fixture connections) are not
hot to the touch (warm is acceptable).
– If a connection is hot, it is due to a loose connection.
– Tighten power connections with your hand or flathead
screwdriver.
– Tighten fixture connections with your hand.
NOTE
It is normal for the halogen bulbs to generate heat.
P
OWER
C
ONNECTOR
5. Connect the Transformer to the Cable
– Using your fingers, unscrew and remove the thumbscrews
from the base of the power connectors.
– Slide each power connector over a cable.
– Replace and tighten the thumbscrews. The connection
must be tight.
– For a clean look, any slack in the power cable can be
pushed into the canopy.
7