Installation Instructions

Pendant

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Mounting Plate

Secure the mounting plate to the electrical box with the

#8-32 screws provided.

Remove the canopy screws using the provided Allen

Wrench.

Remove the mounting plate from the canopy.

#8-32

SCREW

Two Person Installation Recommended

MOUNTING PLATE

ASSEMBLY

#8-32

SCREW

MOUNTING PLATE

ASSEMBLY

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic

dimmer, 0-10V dimmer or TRIAC dimmer.

This instruction shows a typical installation.

CANOPY

SCREW

ALLEN

WRENCH

CANOPY

Installation Instructions for

PAGE 1
Installation Instructions for Pendant GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a low-voltage electronic dimmer, 0-10V dimmer or TRIAC dimmer. This instruction shows a typical installation.
PAGE 2
Assemble the Fixture Install the Fixture 2A 3A FIXTURE WIRES HANG STRAIGHT 3 6" 1 Leave 6" of the wire behind the canopy for power connections. Cut the excess wire. 2 Strip the end of the wires. 1 STEM 3B 1 3 2 4 5 FIXTURE 6 1 Determine desired length of fixture using the provided stems and assemble them by screwing them together. 2 Feed the fixture wires through the stem assembly and screw it to the fixture.
PAGE 3
Optics and Lenses 4A 3C ELECTRICAL BOX CANOPY SCREW ALLEN WRENCH LENS OPTIC LED HOUSING COVER 7 8 Neatly place all wires and wire nut connections inside the canopy. Align the canopy holes with the mounting plate holes. Secure the canopy in place by tightening the canopy screws using the provided Allen Wrench. 1 Unscrew and remove the LED housing cover. 2 Remove the optic. 3 If installing an optional lens, rest the lens inside the housing cover.