Installation & Assembly

2
NOTE: The power cord does not support the fixture.
For a casual “lazy cord” look, cut the power cord
several inches longer that the drop height of the
fixture.
Once the desired look is determined, tighten the set
screw on the strain relief.
Mark the cord underneath the strain relief.
CORD
1C
8
7
8
4"
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. .Make sure not to nick the inner wires
Strip the end of the wires.
1D
Install the Fixture
10
11
9
1
Feed the fixture cord through the mounting plate center
hole. If the cord has a cloth cover, peel back orNote:
remove the cloth where the secondary strain relief is
installed.
Install the secondary strain relief by first feeding the
power cord through it.
Snap the strain relief tab into place.
Pull the cord to take up the slack and fit the rest of the
cord in the strain relief’s openings.
2A
2
3
4
TAB
2
3
4
4
MOUNTING
PLATE
1
FIXTURE CORD