Installation & Assembly

3
2D
Place all wires and wire nut connections properly inside
the canopy.
Loosen the set screw on the strain relief.
Align the canopy center hole with the mounting plate
center hole.
Place the canopy up against the ceiling and secure it in
place by tightening the strain relief into the mounting
plate. Do not turn the cord.
Push the cord into the canopy and line up the marked
point on the cord with the bottom of the strain relief.
Tighten the plastic set screw to secure the cord.
STRAIN RELIEF
CORD
SET SCREW
12
10
11
14
13
15
2E
Adjust the aircraft cables until the fixture is level; feed
the cable into the cable clutch to raise the fixture and
push in on the cable clutch nipple to release the cable
and lower the fixture.
CABLE
CLUTCH
CABLE
CLUTCH
16
16
Connect the mounting plate and the fixture ground
wire to a suitable ground in accordance with local
electrical codes.
Connect the fixture wire with white tracer (white wire)
to the neutral power line wire with a wire nut.
Connect the last fixture wire (black wire) to the hot
power line wire with a wire nut.
2B
5
6
7
NOTE: It is recommended that one person hold the
fixture while the electrician connects the power and
installs the canopy.
MOUNTING
PLATE
5
6
7
8
Place all wires, wire nut connections, and the secondary
strain relief properly inside the electrical box.
Secure the mounting plate to the electrical box with the
two provided #8-32 screws.
2C
MOUNTING
PLATE
#8-32
SCREW
9 9
9