Installation & Assembly

Installation Instructions for

980NEUTO

Install the Fixture

1.0

_OD1012

Wall

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for wet locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Neutrino Outdoor

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

MOUNTING

PLATE

MOUNTING PLATE

FIXTURE

SCREW

Remove the two fixture screws from the sides of the

fixture.

Remove the mounting plate from the back of the

fixture.

ELECTRICAL BOX

#8-32 SCREW

PAGE 1
Installation Instructions for 980NEUTO Neutrino Outdoor OD1012_ Wall GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. This product may be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
1C 1D 4 5 6 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the white fixture wire to the neutral power line wire with a wire nut. 6 Connect the black fixture wire to the hot power line wire with a wire nut. 7 Properly place all wires and wire nut connections into the electrical box and reinstall the fixture base onto the mounting plate (reversal of step 1A).