Installation Instructions

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low voltage electronic dimmer.

This instruction shows a typical installation.

1.0

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Wall

Remove the fixture screws located on the top and bottom of the fixture base using the provided Allen wrench, then remove the mounting

plate from the fixture base.

Install the mounting plate onto the electrical box with the two #8-32 screws provided.

Connect the fixture to suitable ground in accordance with local electrical codes.

Connect the white fixture wire to the neutral power line wire with a wire nut.

Connect the black fixture wire to the hot power line wire with a wire nut.

Properly place all wires and wire nut connections into the electrical box, mount the fixture back onto the mounting plate, and reinstall

fixture screws (reversal of step 1).

Install the Fixture

SAVETHESE INSTRUCTIONS!

MOUNTING PLATE

FIXTURE

FIXTURE SCREW

ALLEN WRENCH

Wall