Installation Instructions

Place all wires and wire nut connections properly inside

the canopy.

Loosen the set screw on the strain relief.

Align the canopy center hole with the mounting plate

center hole.

Place the canopy up against the ceiling and secure it in

place by tightening the strain relief into the mounting

plate. Do not turn the cord.

Push the cord into the canopy and line up the marked

point on the cord with the bottom of the strain relief.

Tighten the plastic set screw to secure the cord.

STRAIN RELIEF

CORD

SET SCREW

Adjust the aircraft cables until the fixture is level; feed

the cable into the cable clutch to raise the fixture and

push in on the cable clutch nipple to release the cable

and lower the fixture.

CABLE

CLUTCH

CABLE

CLUTCH