Installation & Assembly

Installation Instructions for

920FIA

Fia Suspension

SUSPENSION

1.0

700FIA24, 700FIA30, 700FIA48

1.0

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with most ELV, TRIAC, or

0-10V dimmers.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

Tech Lighting reserves the right to change specifications for product improvements without notification.

7400 Linder Ave., Skokie, IL 60077

T 847.410.4400 | F 847.410.4500

www.techlighting.com

PAGE 1
920FIA Installation Instructions for Fia Suspension 700FIA24, 700FIA30, 700FIA48 1.0 SUSPENSION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°C supply conductors.
PAGE 2
Install the Fixture 1A MOUNTING PLATE THREADED NIPPLE #8-32 SCREW 9 8 10 COAXIAL CABLE STRAIN RELIEF CAP NUT 1 Separate the mounting plate from the canopy by unscrewing/removing th cap nut from the threaded nipple. 2 Secure the mounting plate to the electrical box with the two #8-32 screws provided. 3 Place the fixture on a level surface. 4 With the provided Allen wrench, loosen (do not remove) the set screws on the strain reliefs.