Installation & Assembly

Separate the mounting plate from the canopy by unscrewing/removing th cap nut from the threaded nipple.
Secure the mounting plate to the electrical box with the two #8-32 screws provided.
Place the fixture on a level surface.
With the provided Allen wrench, loosen (do not remove) the set screws on the strain reliefs.
Evenly pull the coaxial cables up through the strain reliefs to raise the fixture to the desired height.
NOTE: Take caution to not remove the inner bushing from inside the strain relief while pulling the coaxial cord through.
Ensure that the canopy is level and re-tighten the set screws on the strain reliefs.
SHORTENING THE COAXIAL CORDS:
1A
Install the Fixture
1
2
2
3
4
5
6
7
8
9
10
If shortening of the coaxial cords is necessary, take note of the wire connections from the coaxial cables to the driver and remove
the wire nuts.
Leave 6" behind for wire connections, cut off the excess cord.
From the end of the cord, strip the insulation 4" using a sharp knife. Make sure not to nick the inner wires.
Strip the ends of the wires and reconnect the wires to their original connections using the wire nuts.
A
B
C
D
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line wire with a wire nut.
Connect the black driver wire to the hot power line wire with a wire nut.
Place the canopy onto the threaded nipple and secure it in place by screwing the cap nut onto the threaded nipple.
8
9
10
11
STRAIN
RELIEF
CAP
NUT
SET
SCREW &
ALLEN
WRENCH
THREADED
NIPPLE
#8-32
SCREW
COAXIAL
CABLE
MOUNTING
PLATE