Installation Instructions

1.1

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with using a 0-10V dimmer.

Suitable for wet locations.

Install the Fixture

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

With the provided Allen wrench, back out (do not fully

remove) the set screws on both sides of the fixture.

Remove the mounting plate from the back of the

fixture.

SET

SCREW

MOUNTING

PLATE

ALLEN

WRENCH

Bring conduit and power lines to the fixture location:

conduit may be attached by either the center hole in

mounting plate or the any of the plugs on top of the

fixture. If using the top plugs, unscrew to remove.

MOUNTING

PLATE

CONDUIT TO MOUNTING PLATE

CONDUIT TO FIXTURE

Installation Instructions

Wall

PAGE 1
Installation Instructions Wall 1.1 GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with using a 0-10V dimmer. Suitable for wet locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
1C Warning: The purple and gray wires are only used for 010v dimming. For all other applications, do not connect the gray and purple wires. MOUNTING HOLE LOCATION Note for In-Line Fuse equipped fixtures: in the case that the fixture is not operating correctly, make sure to check the fuse. 4 4 4 4 4 4 4 Note for Photocell equipped fixtures: at initial power up, the photocell must calibrate which will cause the fixture to cycle on/off for a moment.