Installation & Assembly

ManualsBrandsTech Lighting ManualsLightingWit 1 - Light Unique / Statement Tiered LED Pendant

1.0

Installation Instructions for

700TDWIT

920TDWIT

PENDANT

Wit Pendant

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Mounting Plate

Secure the mounting plate to the electrical box with the

#8-32 screws provided.

Remove all the canopy screws using the provided Allen

Wrench.

Remove the mounting plate and driver from the canopy.

#8-32 SCREW

AND WASHER

MOUNTING PLATE

MOUNTING

PLATE

CANOPY

SCREW

1 1

CANOPY

DRIVER

3 3

Two Person Installation Recommended

ALLEN WRENCH

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with most ELV or TRIAC dimmers.

The fixture can be mounted to a ceiling with a 45 degree slope

maximum.

This instruction shows a typical installation.

Summary of content (4 pages)

PAGE 1
920TDWIT Installation Instructions for Wit Pendant 700TDWIT 1.0 PENDANT GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product can be dimmed with most ELV or TRIAC dimmers. The fixture can be mounted to a ceiling with a 45 degree slope maximum. This instruction shows a typical installation.
PAGE 2
Assemble the Fixture 2A 2B MIDDLE MODULE FIXTURE WIRES MALE/FEMALE CONNECTORS 5 Insert the stem with threaded ring on the bottom of it in to the top module through the hole in the acrylic diffuser. 6 Thread the stem into the top module. 2C 7 3 9 2 8 HUB 1 BOTTOM MODULE 1 Screw the module with no hole in the diffuser on to the bottom hub until snug. 2 Connect the wiring harness to a middle module by inserting the male connector into the female connector.
PAGE 3
2D 2E CANOPY PIVOT 13 12 14 STEM 13 Feed the wires into the canopy. 14 Screw the stem assembly to the pivot. 12 2F STEM DRIVER (+) (-) 16 15 (+) (-) 11 CANOPY 10 Determine the desired height of the fixture using the provided stems and assemble them by screwing them together. . 11 Feed the fixture wires through the stem assembly. 15 Connect the blue(-) driver wire to the black fixture wires with a wire nut. 16 Connect the red(+) driver wire to the red fixture wires with a wire nut.
PAGE 4
Install the Fixture (Optional)Access Inner Modules 3A 4A 1 COVER PLATE CONNECTOR 2 3 2 SCREW Due to ventilation holes in the fixture it is possible that cleaning the interior of the glass modules may be necessary. Please turn off power to the fixture and have an assistant support the fixture to prevent damage during this process. It is recommended to have another person hold the fixture up through out this series of steps.