Installation & Assembly

Assemble the Fixture

Screw the module with no hole in the diffuser on to the

bottom hub until snug.

Connect the wiring harness to a middle module by

inserting the male connector into the female connector.

Install the middle module to the hub. Rotate the middle

module counter-clockwise a few turns before tightening

to ensure they catch the threads of the hub. This will

also counter wind the wiring harness to ensure the wires

do not bind.

Repeat until all middle modules are all used.

Insert the stem with threaded ring on the bottom of it in

to the top module through the hole in the acrylic

diffuser.

Thread the stem into the top module.

Feed the wiring harness through the top module and

rigid stem assembly.

Connect one connector to the top module.

Connect the other connector to the module assembly.

FIXTURE

WIRES

MIDDLE

MODULE

HUB

BOTTOM

MODULE

MALE/FEMALE

CONNECTORS