Installation Manual

128 Adding and Configuring iDRAC6 Users
3 On the User Configuration page, configure the following:
• The username, password, and access permissions for a new or existing
iDRAC user. Table 6-3
describes General User Settings .
• The user’s IPMI privileges. Table 6-4
describes the IPMI User
Privileges
for configuring the user’s LAN privileges.
• The iDRAC user privileges. Table 6-5 describes the
iDRAC User
Privileges
.
• The iDRAC Group access permissions. Table 6-6 describes the
iDRAC Group Permissions .
4 When completed, click Apply Changes .
5 Click Go Back To Users Page to return to the Users Page.
Table 6-1. User States and Permissions
Setting Description
User ID Displays a sequential list of user ID numbers. Each field
under User ID contains one of 16 preset User ID numbers.
This field cannot be edited.
State Displays the login state of the user: Enabled or Disabled.
(Disabled is the default.)
NOTE: User 2 is enabled by default.
User Name Displays the login name of the user. Specifies an iDRAC6
user name with up to 16 characters. Each user must have a
unique user name.
NOTE: If the user name is changed, the new name will not
appear in the user interface until the next user login.
iDRAC Displays the group (privilege level) to which the user is
assigned (Administrator, Operator, Read Only, or None).
LAN Displays the IPMI LAN privilege level to which the user is
assigned (Administrator, Operator, Read Only, or None).
Serial Port Displays the IPMI Serial Port privilege level to which the user
is assigned (Administrator, Operator, Read Only, or None).
Serial Over LAN Allows or disallows the user to use IPMI Serial Over LAN.