Installation Manual

Using the iDRAC6 Directory Service 169
12 Click Add to enter the user domain name.
13 Type the user domain name in the prompt and click OK .
14 In the Timeout fields, type the time (in seconds) iDRAC must wait for
Active Directory responses. The default is 120 seconds.
15 Select one of the following options:
a Look Up Domain Controllers with DNS option to obtain the Active
Directory domain controllers from a DNS lookup. Domain Controller
Server Addresses 1-3 are ignored. Select
User Domain from Login to
perform the DNS lookup with the domain name of the login user.
Else, select
Specify a Domain and enter the domain name to use on
the DNS lookup. iDRAC6 attempts to connect to each of the
addresses (first 4 addresses returned by the DNS look up) one by one
until it makes a successful connection. For
Standard Schema , the
domain controllers are where the user accounts and the role groups are
located.
b Select the Specify Domain Controller Addresses option to allow
iDRAC6 to use the Active Directory domain controller server
addresses that are specified. DNS lookup is not performed. Specify the
IP address or the Fully Qualified Domain Name (FQDN) of the
domain controllers. When the
Specify Domain Controller Addresses
option is selected, at least one of the three addresses must be
configured. iDRAC6 attempts to connect to each of the configured
addresses one by one until it makes a successful connection. For
Standard Schema , these are the addresses of the domain controllers
where the user accounts and the role groups are located.
NOTE: The FQDN or IP address that you specify in this field should match the
Subject or Subject Alternative Name field of your domain controller certificate
if you have certificate validation enabled.
16 Click Next . The Active Directory Configuration and Management Step 3
of 4
page is displayed.
17 Under Schema Selection , select Standard Schema.
18 Click Next . The Active Directory Configuration and Management Step
4a of 4
page is displayed.