Installation Manual

250 Configuring Intelligent Platform Management Interface
For example:
racadm config -g cfgIpmiSol -o
cfgIpmiSolBaudRate 57600
c Enable SOL for an individual user.
NOTE: SOL can be enabled or disabled for each individual user.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgUserAdmin -o
cfgUserAdminSolEnable -i
<id> 2
where <id> is the user’s unique ID.
4 Configure IPMI Serial.
a Change the IPMI serial connection mode to the appropriate setting.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgSerial -o
cfgSerialConsoleEnable 0
b Set the IPMI Serial baud rate.
Open a command prompt, type the following command, and press
<Enter>:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialBaudRate
<baud_rate>
where <baud_rate> is 9600, 19200, 57600, or 115200 bps.
For example:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialBaudRate 57600
c Enable the IPMI serial hardware flow control.
At the command prompt, type the following command and press
<Enter>:
racadm config -g cfgIpmiSerial -o
cfgIpmiSerialFlowControl 1