Installation Manual

Using the iDRAC6 Configuration Utility 311
Auto–Discovery
(continued...)
Before adding your Dell system to the network and using the
auto–discovery feature, ensure that:
• Dynamic Host Configuration Protocol (DHCP)
server/Domain Name System (DNS) are configured.
• Provisioning Web services is installed, configured, and
registered.
Provisioning Server This field is used to configure the provisioning server. The
provisioning server address can be a combination of IPv4
addresses or hostname and should not exceed 255 characters.
Each address should be separated by a comma.
If the auto-discovery feature is enabled, and after the
auto-discovery process completes successfully, user credentials
are retrieved from the configured provisioning server to allow
future remote provisioning.
For more information, see the Dell Lifecycle Controller User
Guide available on the Dell Support website at
dell.com/support/manuals.
Account Access Select Enabled to enable the administrator account. Select
Disabled to disable the administrator account or when
Auto-Discovery is enabled.
Account Privilege Select between Admin, User, Operator, and No Access.
Account User Name Press <Enter> to edit the user name and press <Esc> when
you have finished. The default user name is root.
Enter Password Type the new password for the administrator account. The
characters are not echoed on the display as you type them.
Confirm Password Retype the new password for the administrator account. If the
characters you enter do not match the characters you entered
in the Enter Password field, a message is displayed and you
must re-enter the password.
Table 17-3. LAN User Configuration
(continued)
Item Description