Installation Manual

312 Using the iDRAC6 Configuration Utility
System Event Log Menu
The System Event Log Menu allows you to view System Event Log (SEL)
messages and to clear the log messages. Press <Enter> to display the System
Event Log Menu. The system counts the log entries and then displays the
total number of records and the most recent message. The SEL retains a
maximum of 512 messages.
To view SEL messages, select View System Event Log and press <Enter>.
Use <Left Arrow> to move to the previous (older) message and
<Right Arrow> to move to the next (newer) message. Enter a record number
to jump to that record. Press <Esc> when you are through viewing SEL
messages.
To clear the SEL, select Clear the System Event Log and press <Enter>.
When you have finished with the SEL menu, press <Esc> to return to the
previous menu.
Exiting the iDRAC6 Configuration Utility
When you have finished making changes to the iDRAC6 configuration, press
the <Esc> key to display the Exit menu.
• Select Save Changes and Exit and press <Enter> to retain your changes.
If this operation fails, one of the following message is displayed:
– iDRAC6 Communication Failure — Displayed if iDRAC is not
accessible.
– Some of the settings cannot be applied — Displayed when few
settings cannot be applied.
• Select
Discard Changes and Exit and press <Enter> to ignore any
changes you made.
• Select
Return to Setup and press <Enter> to return to the iDRAC6
Configuration Utility.