Installation Manual

Recovering and Troubleshooting the iDRAC6 339
To access the Diagnostics Console page:
1
In the System tree, click iDRAC Settings  Troubleshooting tab 
Diagnostics Console
.
2 Type a command and click Submit . Table 20-2 describes the commands
that can be used. The debugging results appear in the
Diagnostics
Console
page.
3 To refresh the Diagnostics Console page, click Refresh . To execute
another command, click
Go Back to the Diagnostics Page .
Table 20-2. Diagnostic Commands
Command Description
arp Displays the contents of the Address Resolution Protocol
(ARP) table. ARP entries may not be added or deleted.
ifconfig Displays the contents of the network interface table.
netstat Prints the content of the routing table. If the optional
interface number is provided in the text field to the right of
the netstat option, then netstat prints additional information
regarding the traffic across the interface, buffer usage, and
other network interface information.
ping <IP
Address>
Verifies that the destination IP address is reachable from the
iDRAC6 with the current routing-table contents.
A destination IP address must be entered in the field to the
right of this option. An Internet Control Message Protocol
(ICMP) echo packet is sent to the destination IP address
based on the current routing-table contents.
gettracelog Displays the iDRAC6 trace log. For more information, see
gettracelog in the RACADM Command Line Reference Guide
for iDRAC6 and CMC available on the Dell Support website
at dell.com/support/manuals.