Installation Manual

54 Configuring the iDRAC6 Using the Web Interface
Configuring IP Filtering and IP Blocking
NOTE: You must have Configure iDRAC permission to perform the following steps.
1 Click iDRAC Settings  Network/Security and then click the Network tab
to open the
Network page.
Preferred DNS
Server
Configures the static IPv6 address for the preferred DNS server.
To change this setting, you must first clear Use DHCP to
obtain DNS Server Addresses.
Alternate DNS
Server
Configures the static IPv6 address for the alternate DNS server.
To change this setting, you must first clear Use DHCP to
obtain DNS Server Addresses.
Table 4-6. IPMI Settings
Setting Description
Enable IPMI Over
LAN
When checked, indicates that the IPMI LAN channel is
enabled. The default is Off.
Channel Privilege
Level Limit
Configures the minimum privilege level, for the user, that can
be accepted on the LAN channel. Select one of the following
options: Administrator, Operator, or User. The default is
Administrator.
Encryption Key Configures the encryption key: 0 to 20 hexadecimal characters
(with no blanks allowed). The default value is all zeros.
Table 4-7. VLAN Settings
Setting Description
Enable VLAN ID If enabled, only matched Virtual LAN (VLAN) ID traffic will
be accepted.
VLAN ID VLAN ID field of 802.1g fields. Enter a valid value for VLAN ID
(must be a number from 1 to 4094).
Priority Priority field of 802.1g fields. Enter a number from 0 to 7 to set
the priority of the VLAN ID.
Table 4-5. IPv6 Settings
(continued)
Setting Description