User's Manual

e2-Live Home Automation
Edit by Amos /20150810
7
Corresponding to the position of the remote control and setting software
RC-09
Operating device + device + action = first point emission
For example: TV TV Power, the RP-20 will sent emission by the first point of IR infrared signal .
RP-20 software
Control Validation / infrared appliances scenarios set / Appliances
RP-20 first point controls with six IR emitter + a wired control, you can handle most of the device
which is not accommodated in the cabinet environment.
But the remote controller of e2-Lvie is only RC-09, RP-20 remote control software support the
first point emission, if this environment controlled by the first point, it will control in the range of all
of the appliances, we recommend using All emission,the model can achieve the same effect as
well.
All emission support all kind of remote controller of e2-Live. such as RC-09, itouch, VC-1500
Consistent with previous operating mode, HT-100, RP-20 software, etc., select the device (TV,
DVD ...) first, then press (Power, CH +, CH- ....), After RP-20 received, all of the IR emitor will
emission at the same time, no need to specify a fixed point.
The conditions of single point emission are:
There are two same brand device in same space, in order to avoid action together, it will need
to specify a single point of emission
For example, air-conditioned in living room or master bedroom.
Learn the IR signal of air-conditioned to A / C position,
The living room can using the first point emission which can emit to all space of the room.
The air conditioning of the master room can use a single point of independent wiring type
remote control
If both need to be controlled together, you can adopt all points emission.
After pointing device
button and choose
"Point 1" emission.
The RP-20 will send
an infrared signal
from the first IR
emission point.
When the scenario is
set, if want to output
the first point, then
please click on "1",