Manualshelf

User's Manual

ManualsBrandsTechfaith Wireless Technology Group ManualsCell PhonesWCDMA / DUAL GSM MOBILE PHONE
12345678910
User Manual Page 9 of 66
approved by General Mobile.
1.2 Charging the battery
Charging the battery
1. You must charge the battery for at least 4 hours before using the phone for the first time.
2. Open the cover of the mini USB connector located at the left side of the phone. Plug in the charger
connector to the phone and then plug the other end of the charger to the AC outlet.
3. Your phone can be charged while switched on or off.
4. If the phone is charged while turned off, an animated battery charging icon will appear on the screen.
When the battery is fully charged, the battery full icon will appear.
5. If the phone is charged while turned on, a battery icon will flash on the screen with battery capacity
level indicator gradually increasing. The battery icon will stop flashing when the battery is already fully
charged.
6. Unplug the charger from the AC outlet, and then unplug the charger connector from the phone.
1.3 Installing the Memory Card
This phone uses T-Flash memory card or microSD card. You can install the memory card to save images,
media clips, music, and other data on your phone. You can find the memory card slot at the right side of the
phone.
Note: Use only compatible T-flash cards or microSD cards with this device. Other memory cards, such
as Reduced Size MultiMediaCards cards, do not fit in the memory card slot and are not compatible with this
device. Using an incompatible memory card may damage the memory card as well as the device, and data
stored on the incompatible card may be corrupted.
To insert the memory card:
1. Open the memory card slot cover and insert the memory card with the label side facing up.
2. Insert the memory card all the way until it clicks.
3. Close the memory card slot cover.
Removing the memory card:
1. Open the memory card slot cover and slightly push the card so it pops out.
2. Remove the card and close the cover.
Note: Do not remove the memory card in the middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage the memory card as well as the device, and