User's Manual

KIP User Manual
4
1 Start Using
1.1 Battery
The battery is attached with the mobile phone. The battery is not
charged when the mobile phone is purchased but can support power on.
Please recharge it for use after complete use up the battery for the first
three times, which makes this battery easier to achieve the best using
state.
1.1.1 Uninstallation and installation of
battery
 Put the back of the mobile phone upward; press the joint at the top
and remove it according to the chart.
 Dig out the bottom of the battery and get it out.
 When installing the battery, insert the metal teeth at the top of the
battery into corresponding slot of the mobile phone, and then press
the battery down to install the battery in place. The battery must be
ensured to be installed before power on.
 Finally install the rear cover of the mobile phone.
1.1.2 Charging the battery
When the power of the battery was lower than normal, the phone will
prompt battery low. Please charging for the battery, otherwise you will
lose the files which not saved. If you don’t charge or change battery for a
long time, the phone will be powered off automatically.
The battery for the phone is Li battery. Please use the standard
charger and battery, insure the battery’s live time.
 Insert the joint of the charger into the USB jack of the mobile phone.
 Insert the charger to the power source. The battery icon at the right