Installation Manual

Advanced iDRAC6 Configuration 105
7 Set the Telnet terminal ID: to ANSI .
8 Click Terminal Setup and set Screen Rows to 26 .
9 Set Columns to 80 and click OK .
Configuring Serial and Terminal Modes
Configuring IPMI and iDRAC6 Serial
1 Expand the System tree and click iDRAC Settings .
2 Click the Network/Security tab and then click Serial .
3 Configure the IPMI serial settings.
See Table 5-8 for description of the IPMI serial settings.
4 Configure the iDRAC6 serial settings.
See Table 5-9 for description of the iDRAC6 serial settings.
5 Click Apply Changes to a pply the IPMI and iDRAC6 serial changes.
6 Click the appropriate Serial page button to continue. See the iDRAC6
Online Help
for description of the Serial Configuration page settings.
Table 5-7. Management Station COM Port Settings
Setting Description Required Setting
Bits per second 57600
Data bits 8
Parity None
Stop bits 1
Flow control Hardware
Table 5-8. IPMI Serial Settings
Setting Description
Connection Mode
Settings
• Direct Connect Basic Mode - IPMI Serial Basic Mode
• Direct Connect Terminal Mode - IPMI Serial Terminal Mode
Baud Rate • Sets the data speed rate. Select 9600 bps , 19.2 kbps , 57.6 kbps ,
or
115.2 kbps .