Installation Manual

Using the iDRAC6 Directory Service 171
24 Click Apply to save the role group settings.
The iDRAC6 Web server automatically returns you to the
Step 4a of 4
Active Directory Configuration and Management page where your
settings are displayed.
25 Configure additional Role Groups, if required.
26 Click Finish to return to the Active Directory Configuration and
Management
page.
27 Click Test Settings to check the Active Directory Standard Schema settings.
28 Type your iDRAC6 user name and password.
The test results and the test log are displayed. For additional information,
see "Testing Your Configurations" on page 175.
NOTE: You must have a DNS server configured properly on iDRAC to support
Active Directory login. Click iDRAC Settings
 Network/Security  Network page
to configure DNS server(s) manually or use DHCP to get DNS server(s).
You have completed the Active Directory configuration with Standard Schema.
Configuring Microsoft Active Directory With Standard Schema Using
RACADM
Use the following commands to configure the iDRAC Active Directory
Feature with Standard Schema using the RACADM CLI instead of the
Web-based interface.
1
Open a command prompt and type the following RACADM commands:
racadm config -g cfgActiveDirectory -o
cfgADEnable 1
racadm config -g cfgActiveDirectory -o cfgADType 2
racadm config -g cfgStandardSchema -i <index> -o
cfgSSADRoleGroupName <common name of the role
group>
racadm config -g cfgStandardSchema -i <index> -o
cfgSSADRoleGroupDomain <fully qualified domain
name>