Installation Manual

Configuring vFlash SD Card and Managing vFlash Partitions 285
Booting to a Partition
• To list the available devices in the boot list:
racadm getconfig –g cfgServerInfo –o
cfgServerFirstBootDevice
If it is a vFlash SD card, the label names of the attached partitions appears
in the boot list. If it is a standard SD card and if the partition is attached,
then VFLASH appears in the boot list.
• To set a vFlash partition as a boot device:
racadm config –g cfgServerInfo –o
cfgServerFirstBootDevice “<vFlash partition name>”
where, <vFlash partition name> is the label name for vFlash SD card and
VFLASH for the standard SD card.
NOTE: When you run this command, the vFlash partition label is automatically
set to boot once, that is, cfgserverBootOnce is set to 1. Boot once boots the
device to the partition only once and does not keep it persistently first in the
boot order.
Attaching or Detaching a Partition
• To attach a partition:
racadm config –g cfgvflashpartition –i 1 –o
cfgvflashPartitionAttachState 1
•To detach a partition:
racadm config –g cfgvflashpartition –i 1 –o
cfgvflashPartitionAttachState 0