Installation Manual

84 Configuring the iDRAC6 Using the Web Interface
• Internal SD Module Status — Displays the SD card state for SD1, SD2,
and vFlash cards with the following information:
– Status:
• — Indicates that the card is ok.
• — Indicates that the card is offline or write-protected.
• — Indicates that an alert is issued.
– Location — Location of the SD cards.
– Online Status — SD1, SD2, and vFlash cards can be in one of the
states listed in Table 4-25.
Table 4-25. SD Card States
SD Card State Description
SD1 and SD2 Boot The controller is powering up.
Active The card is ready to accept SD read/write requests.
Standby The card is the secondary card. It is receiving a copy of
the all the SD writes.
Failed An error is reported during a SD card read or write.
Absent The SD card is not detected.
Offline At boot, the Card Indentification (CID) signature of the
card is different from the Non-volatile (NV) storage
value or the card is the destination of a copy operation
that is in-progress.
Write
Protected
The card is write-protected by the physical latch on the
SD card. IDSDM cannot use a write-protected card.
vFlash Active The card is ready to accept SD read/write requests.
Absent The SD card is not detected.