User manual

ManualsBrandsTECHNAXX ManualsIntercomsVideo door intercom Radio Complete kit Black

Technaxx

® *

User Manual

Wireless Door Viewer TX-75

Digital door viewer with built-in camera

and 3.5" desk monitor

This device complies with the requirements of the standards referred to the Directive

R&TTE 1999/5/EC. The Declaration of Conformity you find here: www.technaxx.de/

(in bar at the bottom “Konformitätserklärung”). Before using the device the first time,

read the user manual carefully.

This device has a rechargeable battery. It must be fully charged before first

use. NOTE: Charge the battery of the device every 2–3 month if it is not used!

Service phone No. for technical support: 01805 012643 (14 cent/minute from

German fixed-line and 42 cent/minute from mobile networks).

Free Email: support@technaxx.de

Features

 Doorbell function  Photo taking & Photo preview  Data backup up to 100

photos (built-in storage)  Portable desk monitor with 3.5" screen  Camera with

300000 pixel & 170° wide angle view  2.4GHz wireless transmission ~200m open

areas  Power saving function  USB charging function  IP32 camera protection

class (dripping water & <2.5mm impurity)  "Do-it-yourself" installation, camera

placement in peephole

Battery and Charge

● Be sure of the activity of the battery, please fully charge the new battery. ● When

the outdoor unit is at low power, the lamp of emitter would flash. It remains you to

charge. ● The battery of outdoor emitter can be changed or charged by USB. The

green light keeps bright. ● When the handset is at low power (≤ one bar), the red

indicator lamp will flash every second, please charge immediately. ● The handset

can be charged by the USB line, green light keeps bright. ● Charge-and-work

supported. When the battery is charged fully, it auto stops charging. ● Always use the

speccified battery type if needs replacement.

Note: Under low power, display, photo-taking functions cannot work properly.

Summary of content (11 pages)

PAGE 1
Technaxx® * User Manual Wireless Door Viewer TX-75 Digital door viewer with built-in camera and 3.5" desk monitor This device complies with the requirements of the standards referred to the Directive R&TTE 1999/5/EC. The Declaration of Conformity you find here: www.technaxx.de/ (in bar at the bottom “Konformitätserklärung”). Before using the device the first time, read the user manual carefully. This device has a rechargeable battery. It must be fully charged before first use.
PAGE 2
Technical specifications Outdoor Camera & Emitter Camera / Lens 300000 pixels & 170° wide-angle Power supply Replaceable rechargeable lithium battery 7800mAh (type 18650) Charging time ~12 hours Working time ~39 hours continuously ~52 days (monitoring mode) Standby time ~1 year (power saving mode)  charge the battery min. every 6 month Power Consumption 160mA External power DC 5V / 1A Operating temperature –10°C up to +50°C Material Metal / ABS Weight / Dimensions 280g / outline dimensions 3.6 x 0.
PAGE 3
Product Overview Outdoor Camera (installation in peephole) 1 Camera 2 Doorbell button 3 Back side adhesive tape 4 Connection Cable 1 doorbell button of the outdoor camera: Press this button to call. (BLUE LED: shall be on when ring the bell) Emitter 1 USB charging Port 2 Start 4 Connector 5 LED (see following picture) 3 Monitoring mode 6 Code match key Non-monitoring mode (Power saving mode) (see following picture) 3 keys of the Emitter: 1.
PAGE 4
2. Start up key: Insert battery, press this button to confirm mode. 3. Match code key “Reset”: To match code with the indoor handset, incorrect using this button may make device work improperly. Indoor Monitor (Indoor Handset) 1 2 3 4 Switch on/off, match code USB port Charge indicator Preview 5 6 7 8 Photo shooting/Delete Working indicator 3.5 inch display OK 4 keys of the indoor monitor (handset): 1.
PAGE 5
Before installation Insert into both devices the right rechargeable battery (Handset: BP-6M; Emitter: battery pack type 18650), charge both devices (see chapter Battery and Charge) and test the device. For charging the monitor with the table charger, pop up the stand of the handset and insert it into the table charger. Otherwise the handset will not be charged. Also you have to connect the table charger with included USB cable or the included charger. Installation Guide 1.
PAGE 6
Please use the round steel Wire goes board if door peephole is peephole bigger than camera. Hang steel screw. board on Tighten screw to fix steel Tighten screw to fix steel board. board. Connect cable socket to connection base (emitter). Buckle up emitter. through Adjust and fix camera. Cover back. Protect cable before fixing emitter.
PAGE 7
1 2 3 4 5 Door Screw Outdoor camera Emitter Connection wire Battery Installation In the picture you see on the left side the Emitter and on the right side the monitor (indoor handset). 1 = Connector for the battery, 2 = Battery Handset switch on/off Put battery into the handset, press and hold "switch” button (1) for about 3 seconds to start up. Screen shows the starting page and enters into standby mode. Display: The standby image, signal icon, power icon. Press “OK” button to turn off the screen.
PAGE 8
1 2 3 4 5 6 Switch on/off USB port Signal Emitter battery indicator Handset battery indicator OK Modes setting 1. and 2. with ARROW UP: Non-power saving setting: Switch to “ON” to select nonpower saving mode, and press “Start” to confirm. In this mode, you can monitor outside by pressing “OK” button on the monitor. 1. and 2. with ARROW DOWN: Power saving setting: Switch to “OFF” to select power saving mode, and press “Start” to confirm.
PAGE 9
Doorbell: Press doorbell, indoor monitor shows live video from outside and rings for 30s. Press “OK” to stop ringing; Press “OK” again to turn off screen. Photo taking: Start taking photos: Monitor is ON and live video is shown  Press to take one photo  one press one photo. End taking photos: Press “OK” to turn off screen. Photo Preview (in standby mode and when screen is on): Preview: Press , show the latest photos. Press Exit: Press to exit. again to check previous photo.
PAGE 10
Left side: Monitor (indoor handset) Right side: Emitter 1 2 3 Power Switch Reset Start Hazard, safety and warning notices ► Incorrect use of the device and accessories can be dangerous for you and others and can damage or destroy your device. We therefore ask you to read and strictly observe the following Hazard, safety and warning notices. ► This device has been designed for private use and is not suitable for commercial purposes.
PAGE 11
► Do not drop or bump device and always handle it with due care. Otherwise it can be damaged. ► Do not operate your device whilst running or driving. You could fall or cause a traffic accident. ► Damage to the electronics or lens caused by extraneous effects such as knocks, falls or others are not covered by the guarantee. Special attention for operation of charger You may charge the device with a charger or through a USB data line connected to the computer.