Manual

P A G E 14
D I P A N D F L O W C O O L E R S U S E R ’ S M A N U A L
Carrying a Dip Cooler
A support clip is provided which should be fixed to the side of the
unit if it is required to move the unit frequently. It not only makes it
easier to carry it also protects the flexible hose. The support clip
consists of a block and a long screw. To fit it to the Cooler, remove
the screw in the cover at the rear on the opposite corner to the coil,
the long screw goes through the block and replaces the screw just
removed. There is a lip on the block which should fit over the edge
of the cover to give the support stability. The coil is then clipped into
the support for ease of carrying.
RU-500 RU-200
Cleaning your unit
Before cleaning your unit, disconnect from the power supply and
allow to cool to ambient temperature.
You can clean the case of the refrigerated unit with a cloth dipped in
water or ethanol (methanol or formaldehyde can also be used). No
part of the case or cover should be immersed in the solvents.
Do not use acetone or abrasive cleaners.
Packing
When you receive your unit, make sure you keep the original
packing in case you ever need to return it for service or repair.
The unit must be transported in the original packing to avoid
damage. Techne accepts no responsibility for damage incurred
unless the unit is correctly packed and transported in this way.