Instructions / Assembly

With the side panels Ⓓand Ⓔ oriented as shown, assemble the sliders Ⓠ using screws

④, making sure the smaller rails attach to the panels, and the larger rails slide in and out.

TIP: Assemble first on the back holes of the sliders

P.8

RTA-5004

P.8

STEP 10

Hardware/tools:

❹

Pcs

(NOT INCLUDED)

(Front)

(The grooves are at the back of the panels)

(The smaller rail gets

attached to the panels; the

larger rail slides in and out)

Please pay attention to which holes to use on the sliders

STEP 11

Hardware/tools:

❶

Pcs

❷

Pcs

❸

Pcs

(NOT INCLUDED)

(Top surface)

Refer to page 4

(Front)

(The grooves are at the

back of all the panels)

Wooden pins ① on outer holes;

Cam bolts ② on inner holes

(This view is from the

front facing to the right)

First insert the wooden pins ① into the innermost set of holes on the top surface of bottom

panel Ⓖ, then attach the cam bolts ② into the outermost sets of holes; then insert and

align the cam locks ③ into the bottom sets of holes on the side panels Ⓓ and Ⓔ and

finally, assemble the side panels to Ⓖ as shown and as explained in page 4.