ASSEMBLY INSTRUCTION MODEL RTA-1460 Thanks for purchasing one of our products. Please read carefully the assembly instructions before the installation.
0.9’’ 47.25’’ 28.74’’ 13.7” 2.24” 12.8” 2.24” 24.9” 3.8” TOP WEIGHT LIMIT:50Lbs SMALL DRAWER WEIGHT LIMIT:10Lbs BIG DRAWER WEIGHT LIMIT:15Lbs DO NOT exceed this limit. 15.4” 26.7” 13.7” 3.
RTA-1460 P.
RTA-1460 P. 4 SCREWS PART QTY . ITEM A 13 B 1 C 16 6x40 MM CAM BOLT D 16 6x40 MM CAM LOCK E 24 F 5 WOODEN PIN G 11 3.8X35 MM H 4 4X18 MM PART WOODEN PIN QTY . ITEM 1 GLUE 3.5X12 MM NOTE:CORRECT USE OF B WITH A HOW TO ASSEMBLE USING BOLTS AND CAM LOCKS ALIGNING THE CAM LOCK CORRECT INCORRECT Cam bolt Cam lock A1. Longer groove on cam lock must be pointing to the hole where th e cam bolt enters in the panel. Use the screwdriver to turn to the correct position. A2.
1460 5
RTA-1460 P. 6 Attention:Do not tighten the screws until all of them are in right positions WARNING:HOLES ON PANELS MAY BE HIDDEN UNDERNEATH PVC LAMINATE!!! STEPS 1 C Left 15 E C 2 C Right 15 C E 1 2 Assemble one of the flat sliders (15) to the right structure (2) using 3 screws (E), with the wheel facing to the front. Then screw 2 bolts (C) on the back of the structure as shown.
RTA-1460 P. 7 STEPS 5 3 2 D A Instructions on page 4 1 Insert wooden pins (A) into the structures (1) and (2) as shown. Assemble the back panel (3) in between the 2 structures using cam locks (D). 6 Insert 7 wooden pins (A) into the structures (1) and (2), and the back panel (3) as shown. Then carefully assemble the main panel (5) using cam locks (D).
RTA-1460 P. 8 STEPS 7 Use screws (G) to secure the back panel (3) as shown. G 3 8 9 Right G 15 E Left 7 E 9 8 9 15 Assemble the sliders (15) to the bottom of all panels (7) and (9) using screws (E) as shown, with the wheels facing to the front of the panels. The channels on all panels will be at the bottom and facing towards the inside. G 7 Assemble the panel (8) in between 1 panel (7) and 1 panel (9) using screws (G) as shown.
RTA-1460 P. 9 STEPS 10 11 C 16 6 10 H 11 C D F D F F Screw bolts (C) to panel (6) and insert wooden pins (F) as shown. G Assemble the panel (11) to the panel (8) using screw (G) as shown. Make sure the hole for the cam lock on panel (11) is facing outwards. Then slide the panel (10) Then assemble panel (6) in between the panels, making sure it enters into all the using cam locks (D) as shown. Finally, assemble the Instructions on page 4 channels. handle (16) using screws (H).
RTA-1460 P. 10 STEPS 14 Insert both drawers as shown.
