Instructions / Assembly

ManualsBrandsTECHNI MOBILI ManualsExecutive ChairsBlack Modern Medium Back Executive Office Chair

Table Of Contents

M8x25mm, x4

ASSEMBLY INSTRUCTIONS FOR CHAIR MODEL

RTA-4602

PARTS LIST

ATTENTION: Before you begin the assembly,

make sure that all parts are included in good

condition.

ATTENTION:

⚠ Follow the instructions step by step.

⚠

To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.

⚠

Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.

⚠

Using the wrong size of screws on a part could result in damage to the screw or the part.

Seat, x1

Mechanism,

Hydraulic

Gas Lift, x1

Connectors, x2

(Armrests)

Star Base, x1

Caster, x5

M8x60mm

M8x50mm, x2

Allen wrench, x1

, x2

Insert the casters (F) into the legs of the base(C) using pressure,

then place the gas lift (E) in the middle of the base as shown.

With the seat (A) positioned as shown, assemble the

armrests (B) to the back using connectors(G) and screws(J) ,

assemble the armrests to the seat using screws(K) as shown.

Pay attention to the correct screws you have to use.

With the seat (A) positioned as shown, assemble

the mechanism (D) using washers (H) and screws (I).

Please note that once the chair is assembled, the handle

will be on the RIGHT side and the

tension knob will face

towards the front of the chair.

(Mechanism)

Tighten well all the screws before you

sit on the chair for the first time.

Armrests, x2

(Armrests)

☛

Both arms are the sam

Washers, x4

Place the seat over the base, making sure the tip of the gas

lift enters into the hole of the mechanism

Summary of content (2 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS FOR CHAIR MODEL RTA-4602 ATTENTION: PARTS LIST ATTENTION: Before you begin the assembly, make sure that all parts are included in good condition. A Seat, x1 G Connectors, x2 ⚠ Follow the instructions step by step. ⚠ To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places. ⚠ Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.
PAGE 2
CHAIR’S FUNCTIONS: (1) To raise or lower the chair’s height, pull UP the lever that is under the seat. The chair goes down while sitting on it, or up if you lift your body. (2) To make the chair tilt, pull the same lever OUT horizontally to unlock this function, and IN to lock again. (3) To adjust the tension for the tilting function, turn the mechanism’s knob in either direction to apply more or less tension. (1)/(2) (3) WARNINGS: • Do not stand up on the chair or use it as ladder.