Instructions / Assembly

CHAIR’S FUNCTIONS
① To raise or lower the chair’s height, pull UP the lever that is under the seat. The chair
goes down while sitting on it, or up if you lift your body.
② To make the chair tilt freely, pull the same lever OUT horizontally to unlock this
function. When the chair is in the normal position, push the lever IN to lock again.
③ To adjust the tension for the tilting function, turn the mechanism’s knob in either
direction to apply more or less tension. With less tension, the tilting will feel easier.
④ To use the chair as if it was armless, just flip the arms up.
⑤ To adjust the headrest’s height, pull the knob located on the front and at the same
time lower or raise the headrest; release the knob when the desired height is reached.
WARNINGS
• Do not exceed the indicated weight limit.
• Do not stand up on the chair or use it as ladder.
• Use the chair to seat only one person at a time.
• Do not use the chair if parts are damaged or if screws are loose or missing.
• Do not sit near the edge of the seat and always sit properly on the chair to avoid going
beyond your balance point and fall off the chair.
• The chair is intended for teenagers and adults. If small children are using the chair,
please keep close observation on them.
• Do not allow small children to play with the chair.
• Not paying attention to these warnings could result in severe injuries.
• To clean the chair it is recommended to use a soft cloth lightly damped in a solution of
smooth soap and water, then dry with a clean towel.
• Do not use solvents or abrasive materials to clean any part of the chair.
• Before applying a cleaning agent, test on a small hidden area of the chair, like
underneath the seat.
• Do not expose the product to direct sunlight or to extreme environmental conditions.
• Every 4 months, inspect the chair completely and make sure that all screws are
tighten.
CARE AND MAINTENANCE
P. 5
RTA-80X5
P. 5
5
4
3
2
1