Instructions / Assembly

P.11
RTA-8409
P.11
With the drawer upside-down and its front facing away from you, assemble the “L” shaped
sliders (14) using screws (5) as shown.
First attach the handle (7) to the drawer front panel (N) using the same screws that come
with the handle from inside the drawer, then cover the cam locks on the side panels with (9).
Install the metal pins (8) in the desired sets of
holes inside the unit, and place the adjustable
panel (K), and then insert the drawer as shown.
If the drawer does not fit, please
review the correct assembly of the
Sliders in page 6/step 4, and page
11/step 19.
ENJOY YOUR NEW UNIT!
STEP 19
Hardware:
5
M3.5x16m
x4
(Same parts as step 17, but
shown upside-down with front
panel facing away)
STEP 20
Hardware:
7
Handle
x1
7
M3.6x24mm
x2
9
15mm
x2
STEP 21
Hardware:
8
Metal pin
x4
ATTENTION:
VERY
IMPORTANT!
(Same parts as step 19,
but shown flipped upright
with front panel facing away)
DONE!
Before you start using the
unit, make sure that all the
screws, bolts, cam locks,
etc. are properly tightened,
and read all the warnings
in the next page.