Instructions / Assembly

Loosen the screw indicated in the illustration on the hinges ⑮ and separate the parts:
• The small parts ⓐ will be used on the next step.
• The big parts ⓑ will be used until step 17, please set them aside.
STEP 9
Hardware:
❼
10#x1/2”
4
Pcs
⓭
Hinge “a”
2
Pcs
You might also need to tighten this
screw a little bit.
Assemble the small hinges ⑮ⓐ to the plastic bases ⑫ on panel Ⓓ using screws ⑦ as
shown.
STEP 8
Small parts ⓐ will be
used on next step.
Big parts ⓑ will be
used until step 21.
15a
PAY ATTENTION TO THE
ORIENTATION OF THE PARTS
1
st
: Install and align the cam locks ⑨ into panel Ⓒ in the locations indicated.
2
nd
: Assemble the panel Ⓛ to panel Ⓒ as shown and as explained in page 4.
3
rd
: Join the panel Ⓖ to panel Ⓒ as shown (wooden pins enter into the holes).
STEP 10
Hardware:
❾
Cam lock
2
Pcs
PAY ATTENTION TO THE
ORIENTATION OF THE PARTS
(Right)
(This view is from the underside of the unit)
SEE PAGE 4
DO NOT REMOVE THE
SCREWS FROM ANY
OF THE 2 PARTS.
P.8
RTA-8807
P.8