02'(/ 57$ $66(0%/< ,16758&7,216 7KDQN \RX IRU SXUFKDVLQJ RXU SURGXFWV 6FDQ 45 &RGH WR YLHZ IXOO DVVHPEO\ YLGHR
3 57$ 3OHDVH UHDG FDUHIXOO\ WKH DVVHPEO\ LQVWUXFWLRQV EHIRUH WKH LQVWDOODWLRQ 'R QRW GLVFDUG WKLV PDQXDO RU DQ\ RI WKH SDFNDJLQJ PDWHULDO XQWLO WKH XQLW KDV EHHQ FRPSOHWHO\ DVVHPEOHG 6FDQ 45 &RGH WR YLHZ IXOO DVVHPEO\ DQG VWHS YLGHR 0LJKW UHTXLUH WZR SHRSOH 3
57$ 3 3 MAIN PARTS LIST $ Bottom divider panel [ % Middle shelf [ & Left panel [ ( Bottom panel [ ) Top divider panel [ * Bottom back panel [ + Top main panel [ , Door [ - Top back panel [ ' Right panel [ MAIN PARTS LAYOUT ( FOR REFERENCE ): + ) & ) % ( $ ' , - , *
57$ 3 3 SCREWS LIST: 1DLO 47< ,7(0 1 3FV :RRGHQ 3LQ 0HWDO 3LQ 2 6HWV &DP ORFN DQG EROW 'RRU 6WRSSHU 3 3FV Screw [ PP 4 3FV Screw [ PP 3$57 3ODVWLF )HHW 0DJQHW 6HW ☛ This unit uses cam bolts and locks. The following explains how to use them. This is not an assembly step; it is a guide for when you are actually doing the assembly using this kind of hardware. Cam Bolt 1. Screw the bolt into the corresponding panel. Cam Lock 2.
3 57$ 3 BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS. ❶ Do a quick inventory to make sure the package contains all the parts and hardware listed in the assembly instructions. ❼ To avoid misalignments, always leave the screws loose and tighten them until all pieces are positioned correctly. ❷ Missing, damaged and defective parts can be replaced at no cost to you. Please refer to the CONTACT card included with the product.
57$ 3 3 ASSEMBLY STEPS Insert the wooden pins ( 1 ) into panels ( A - B - C - D - F ) as shown. STEP 1 Hardware: ) ) x24 $ 6FDQ 45 &RGH WR YLHZ WKLV VWHS ' & ATTENTION: Make sure to insert the Wooden Pin in the correct holes, as some other holes are intended for the cam bolt!. % $77(17,21 '2 127 -2,1 $1< 3$576 ,1 7+,6 67(3 Attach Door Stopper ( 7 ) to the RIGHT side of panel ( A ) and panel ( C ) as shown.
57$ 3 STEP 3 Remove the top caps from the Plastic Feet ( 8 ) and assemble the to bottom panel ( E ) using screws ( 3 ) as shown. Hardware: x20 x5 6FDQ 45 &RGH WR YLHZ WKLV VWHS ( STEP Attach the magnets ( 9 ) to the bottom panel ( E ) with the magnets facing to the front as shown, and save their screws to use in step number 8.
57$ 3 3 Assemble panel ( A ) to panel ( E ) as shown and secure with screws ( 4 ). STEP Hardware: x2 $ E 6FDQ 45 &RGH WR YLHZ WKLV VWHS STEP Join the middle panel ( B ) to panel ( A ) ( no screws are needed here ). Another person should keep holding this part during steps 7 through 10.
57$ 3 3 Attach the screws from the magnet set ( 9 ) to both door panels ( I ), then place both metal pins ( 6 ) as shown. STEP Hardware: x4 x4 6FDQ 45 &RGH WR YLHZ WKLV VWHS 9 , Place the door ( I ) on the left side in between panels ( A ) and ( C ), then secure the panel ( C ) using screws ( 4 ) as shown.
57$ 3 Place the door ( I ) on the right side in between panels ( A ) and ( D ), then secure the panel ( D ) using screws ( 4 ) as shown. STEP 1 Hardware: 3 2 PERSONS REQUIRED x2 $ I ( ' 6FDQ 45 &RGH WR YLHZ WKLV VWHS ( ' STEP Attach Cam Bolt ( 2 ) to Top Main panel ( H ) as shown.
57$ 3 3 Attach panels ( F ) to panel ( B ) as shown STEP ) 6FDQ 45 &RGH WR YLHZ WKLV VWHS ) % Insert the Cam Locks ( 2 ) into the holes of panels ( C ), ( D ) and ( F ) and align them as it is explained on page 4. Them assemble the main panel ( H ) as shown and as it is explained on page 4.
57$ 3 Assemble the back panels ( G ) and ( J ) with their finished surfaces facing towards the inside of the stand, using Nails ( 5 ) as shown. The plain surfaces will face the outside. STEP Hardware: 3 x50 6FDQ 45 &RGH WR YLHZ WKLV VWHS J 5 G ( Plain surface facing outside ) ),1$/ 67(3 ALL '21( *LYH \RXUVHOI D QLFH SDW RQ WKH EDFN
57$ 3 2 3 2 AFTER THE ASSEMBLY IS DONE, PLEASE READ CAREFULLY THE FOLLOWING WARNINGS FOR CARE AND MAINTENANCE: t /',d >/D/d^ STORAGE A >ďƐ͘ STORAGE B >ďƐ͘ TOP 🅐🅐 🅑🅑 >ďƐ͘ 🅐🅐 🅑🅑 🅐🅐 Do not exceed the indicated weight limits. Do not expose the surfaces to direct sunlight or to extreme environmental conditions. Damages caused by this kind of exposure is not covered by the product's warranty.
