Instructions / Assembly

3
57$
3
BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
❶ Do a quick inventory to
make sure the package contains
all
the parts and hardware listed
in the assembly instructions.
❷ Missing, damaged and
defective parts can be
replaced at no cost to you.
Please refer to the CONTACT
card included with the product.
❸ The replacement parts service
is limited to the continental United
States. If you reside in Hawaii,
Puerto Rico, U.S. Dependencies
or other countries, please contact
the supplier from where the unit
was purchased.
❹ If
during assembly you find
an issue or need clarification,
please contact our Customer
Service
for assistance. Ple
ase
refer to the
CONTACT card
incl
uded with
the product.
❺ O
n
each st
ep read the
instructions and analyze the
illustrations
t
horo
ughly
before proceeding to do the
assembly.
❽ Do not overtighten or
force the screws as they
might break,
strip, damage
the threads of the holes or
get stuck inside the part.
❻ Make sure you understand
which hardware will be used on
each step. Using the
wrong
size of screw, bolt or pin might
strip the threads or cause
damage to the part in which it is
being used.
❼ To avoid misalignments,
always leave the screws loose
and tighten them until all
pi
eces are positioned correctly.
❾ Sometimes the laminate might cover partially or
ent
irely
t
he hole on a panel. If there is no visible hole for the screw,
pass and press the tip of your finger over the area where the
hole should be located to feel the indentation, and once
found, carefully pierce the laminate to reveal the hole
underneath.
❿ If the hole seems too small for the screw, first make sure
you are using the correct size of screw and that it’s been
installed in the correct hole. If the hole still appears to
be too
small, carefully pierce the laminate to reveal the hole’s actual
size.