Instructions / Assembly

66
RTA-980FBC
P.P.
STEP 5
Hardware/Tools
B
4
pcs
6x35
Drill Ø6mm
NOT INCLUDED:
Wall
21-11/16" (550 mm)
6-5/16"
(160 mm)
B
Wall
Drill ø6mm
Height as
you desire
IMPORTANT: The measurements given here should make the holes on the wall coincide with
the holes on the metallic supports, however, there is always a small chance that they might not
exactly coincide by mere millimeters. You should always check and compare the measurements
on the supports against the markings on the wall before drilling any holes.
Ÿ Select the height you want to fix the product on your wall.
Ÿ Use a pencil (not included) to mark on the wall where it would be the bottom left hole.
Ÿ From this marking, use a measuring tape and a lever (not included) to find and mark the left
top hole. We recommend measuring in millimeters for better accuracy.
Ÿ In the same manner, find and mark on the wall the right top and right bottom holes.
Ÿ Verify that the markings on the wall coincide with the holes on the unit.
Ÿ Once the markings are verified, use a power driller with Ø6mm drill bit (not included) to make
the 4 holes on the wall.
Ÿ After drilling the holes, use a hammer (not included) to insert the anchors.
After marking, proceed to
drill the 4 holes.
After drilling the holes, proceed
to insert the anchors.