Instructions / Assembly
Table Of Contents
- RTA-S06 Page 0 (Front cover)
- RTA-S06 Page 1 (Main Parts list - 1)
- RTA-S06 Page 2 (Main Parts list - 2)
- RTA-S06 Page 3 (Tips and warnings)
- RTA-S06 Page 4 (Cam Bolt-Lock tutorial)
- RTA-S06 Page 5 (Steps 1, 2)
- RTA-S06 Page 6 (Steps 3, 4)
- RTA-S06 Page 7 (Steps 5, 6)
- RTA-S06 Page 8 (Steps 7, 8, 9)
- RTA-S06 Page 9 (Steps 10, 11)
- RTA-S06 Page 10 (Steps 12, 13, 14, 15, 16)
- RTA-S06 Page 11 (Steps 17, 18, 19)
- RTA-S06 Page 12 (Steps 20, 21, 22, 23, 24)
- RTA-S06 Page 13 (Step 25, Troubleshoot)
- RTA-S06 Page 14 (Weight limits, Warnings, Care)
- RTA-S06 Page 15 (Warranty)
P.3 P.3
RTA-S06
BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
M6
30mm
M6x30
• Make sure you understand which
hardware will be used on each step. Using
the wrong size of screw, bolt or pin might
strip the threads or cause damage to the
part in which it is being used.
• To avoid misalignments, always leave the screws
loosely and do not tighten them until all the pieces
are positioned correctly.
• Do not overtighten or force the screws as they might
break, strip, damage the threads of the holes, or get
stuck inside the parts.
• If the hole seems to small for the screw, make sure
you are using the correct size of screw and/or that
you are installing it in the correct hole.
• Sometimes on the wood panels the laminate or
material might be covering the hole partially or
entirely, if there is no visible hole or if it looks too
small, pass and press the tip of your finger over the
area to feel its indentation, and carefully pierce the
laminate to uncover the hole underneath.
√
√
• Please read the assembly instructions throughly and
follow step by step.
• After the item is assembled, you can use rubbing
alcohol to erase or remove the visible part
numbers printed or labeled on the pieces.