Assembly

5
6
7
3
5PCS
7
8
9
10
9
8
Make sure all the Casters (3) have the ring, and
insert into the Base (7) by applying force.
Make sure all the Casters (3) have the ring, and
insert into the Base (7) by applying force.
Aseg rese que todas las ruedas (3) tengan los
aros, e ins rtelas en la base (7) aplicando fuerza.
ú
é
Insert the Gas Lift (8) into the
center of the Base (7).
Insert the Gas Lift (8) into the
center of the Base (7).
Ensamble el Cilindro
Pneumatico (8) a la Base(7).
Place the Mechanism (9) over the
Gas Lift (8).
Place the Mechanism (9) over the
Gas Lift (8).
Ensamble el Mecanismo (9) con el
Cilindro Pneumatico (8).
Tighten all screws well
and enjoy this unique
laptop desk!
Tighten all screws well
and enjoy this unique
laptop desk!
Ajuste bien todos los
Tornillos y disfrute este
mueble unico !
1
9
D
4PCS
6X12 MM
Using Screws (D) , attach the
Mechanism (9) to the Bottom
Panel (1).
Using Screws (D) , attach the
Mechanism (9) to the Bottom
Panel (1).
Use Tornillos D para fijar el
Mecanismo (9) a la cara posterior
del Panel Inferior (1)
Height Adjustment: push the
handle (9) upwards to adjust to
desired height. To lower the table,
pull the handle (9) again while
pushing down from the top of the
table.
Height Adjustment: push the
handle (9) upwards to adjust to
desired height. To lower the table,
pull the handle (9) again while
pushing down from the top of the
table.
Ajuste de Altura: Hale la manila (9)
hacia arriba para ajustar la altura.
Para bajarlo, hale la manilla (9)
nuevamente presionando la mesa
hacia abajo.
SCREWS SCREWS TORNILLOS
8
7
11
7
Slide the Base Cap (11) over the
Base (7).
Slide the Base Cap (11) over the
Base (7).
Deslize la tapa de la base (11)
sobre la Base (7).
ATTENTION: In most cases, the Base
Cap (11) is already inserted into the
Base (7) at the factory.
ATTENTION: In most cases, the Base
Cap (11) is already inserted into the
Base (7) at the factory.
Atencion: En la mayoria de los casos, la
Tapa de la base (11), viene de Fabrica,
ya insertada sobre la Base (7).
RTA-SIB006
P. 6