User's Manual

PRESS ENTER

No boot device was found. This could mean that either a

boot drive was not detected or the drive does not contain

proper system boot files. Insert a system disk into Drive

A: and press <Enter>. If you assumed the system would

boot from the hard drive, make sure the controller is

inserted correctly and all cables are properly attached.

Also be sure the disk is formatted as a boot device. Then

reboot the system.

DISKETTE DRIVES OR

TYPES MISMATCH ERROR -

RUN SETUP

Type of diskette drive installed in the system is different

from the CMOS definition. Run Setup to reconfigure the

drive type correctly.

DISPLAY SWITCH IS SET

INCORRECTLY

Display switch on the motherboard can be set to either

monochrome or color. This indicates the switch is set

to a different setting than indicated in Setup. Determine

which setting is correct, and then either turn off the

system and change the jumper, or enter Setup and

change the VIDEO selection.

DISPLAY TYPE HAS

CHANGED SINCE LAST

BOOT

Since last powering off the system, the display adapter

has been changed. You must configure the system for

the new display type.