User's Manual

CHAPTER 4 INSTALLATION

4.1 MFIII-845GV/GE Mini Desk Top PC system installation

The following is the Mini Desk Top PC system installation procedure step by

step which will guide you to install the mini desk top PC system as much as

easier.

Step1: Open the case upper cover.

Step2: Installing the L shape power supply by screw in the 5 screws.

Step3: Installing the power switch by screw in the 2 screws.

Step4: Installing the second fan by screw in the 4 screws. The second fan is

located between the case front side panel and the front bezel

( optional ).

Step5: Installing the following parts on the front bezel before install the

front bezel in to the case. .

a. Reset switch with wire.

b. HDD LED with wire.

c. Power LED with wire.

d. Network LED with wire

e. Power switch Button.

Step6: Installing the front bezel into the case by screw in the 5 screws and

push in the above wires (step 5, a, b, c, d, e) and the second fan wire

into the case to connect to the motherboard and the power supply.

Step7: Installing the 3-supporting bracket on the lower case.

Step8: Installing the hard disk drive, if necessary. To install the hard disk

drive, please follows the step below:

a. Removes the HDD/FDD/CD-ROM drives mounting bracket by

unscrew the two screws.

b. Install the hard disk drive on the lowest bottom of the

HDD/FDD/CD-ROM drive-mounting bracket by screw in the 4

screws at the side.

c. Connects the 40 pins HDD flat cable into the hard disk, pin 1

close to DC power connector of the hard disk drive.

d. Connects the power cable to the hard disk. The power cable is