User's Manual

only one way direction.

e. Align the Hard disk drive position 1.5cm away from the front

panel position of the case. This will guide you to line up the

hard disk drive with the front bezel.

f. Install the HDD/FDD/CD-ROM mounting bracket by screw in

the 4 screws.

Step9: Installing the floppy disk drive, if necessary. To install the floppy

disk drive, please follows the step below:

a. Inserting the floppy disk drive from the front end of the case by

slide into the FDD slot location.

b. Connects the 34 pins FDD flat cable into the floppy disk drive,

pin 1 close to DC power connector of the floppy disk drive.

c. Connects the power cable to the floppy disk drive. The power

cable is only one way direction.

d. Align the floppy disk drive to be line up with the front bezel and

screw in the 4 screws of the FDD side screws.

Step10: Installing the CD-ROM drive, if necessary. To install the CD-ROM

drive, please follows the step below:

a. Inserting the CD-ROM drive from the front end of the case by

slide into the CD-ROM slot location.

b. Connects the 40pins CD-ROM flat cable into the CD-ROM

drive, pin 1 close to DC power connector of the CD-ROM

drive.

c. Connects the power cable to the CD-ROM drive. The power

cable is only one way direction.

d. Align the CD-ROM drive to be line up with the front bezel and

screw in the 4 screws of the CD-ROM side screws.

Step11: Installing the CPU by inserting it into the CPU socket on the

motherboard, and set correct CPU bus speed at JP8 , please refer to

page No.15 of this manual for detailed CPU bus speed setting for JP8.

After finished the CPU installation, then install the CPU cooling fan

on the top of CPU.

Step12: Installing the 184 pin DDR DIMM memory on the motherboard.

Step13: Installing the motherboard into the case by slide in the motherboard

horizontally with the base of the case until all the connectors

matching up with holes of the back panel of this case, please make

sure that the motherboard screw holes (total 4 screw holes) also

matching up with base mounting holes of the case. Screw-in the 4

screws for the motherboard and also screw in the VGA connector and