User's Manual

24
If this item is enabled, it checks the size of the floppy disk drives at start-up time.
You donʺt need to enable this item unless you have a legacy diskette drive with
360K capacity. The default is Disabled.
Options : Enabled , Disabled.
Boot Up NumLock Status
This controls the state of the NumLock key when the system boots. The default is
On.
On : The keypad acts as a 10-key pad.
Off : The keypad acts like cursor keys.
Gate A20 Option
This refers to the way the system addresses memory above 1 MB (extended
memory ). The default is Normal.
Normal : The A20 signal is controlled by the keyboard controller or chipset
hardware.
Fast : The A20 signal is controlled by Port 92 or chipset specific method.
Typematic Rate Setting
This determines the keystrokes repeat rate.The default is Disabled.
Enabled : Allows typematic rate and typematic delay programming.
Disabled : The typematic rate and typematic delay will be controlled by the
keyboard controller in your system.
Typematic Rate (Chars/Sec)
This is the number of characters that will be repeated by keyboard press. The
default is 6.
Options : 6~30 characters per second.
Typematic Delay (Msec)
This setting controls the time between the first and the second character displayed
by typematic auto-repeat. The default is 250.
Options : 250/500/750/1000 msec.
Security Option
This category allows you to limit access to the System and Setup, or just to Setup.
The default is Setup.
System : The system will not boot and the access to Setup will be denied if the
correct password is not entered at the prompt.